Beier Machinery specialize in providing you with plastic recycling machine for PE,PP,PET,film,plastic granulator,plastic pelletizer.
You are here: Home » News » What Are Problems That Plastic Granulator Should Pay Attention To During Operation?
What Are Problems That Plastic Granulator Should Pay Attention To During Operation?

The correct operation of plastic machines has been used to extend their life. However, the use of plastic machinery has not received enough attention in our daily lives, and at the same time it has caused some unnecessary problems. Then we use plastic granulators. What issues should be noticed?
1. Pay attention to fire safety. The fire extinguisher needs to be placed near the equipment that uses the thermal oil.
2. When the plastic granulator fails or abnormal, it must report the relevant personnel and it is handled by professional maintenance personnel. If an abnormality that affects safety is found, immediately press the emergency stop switch.
3. Do not use low-quality materials with metal impurities or sediment. Do not place metal objects that may fall into the material inlet to prevent the screws or barrels from being worn or causing jamming or damage.

plastic-granulator

4. The plastic granulating machine should be operated with hydraulic fluids whose cleanliness and viscosity are in compliance with the requirements, and provide enough cooling water for the oil cooler according to the regulations, so as to avoid hydraulic elements and pipelines from being congested or leaking due to oil pollution or high temperature. Oil and other damage. The extruder should fill the reducer with the required lubricant.
5. When the plastic pelletizer is operated, it shall strictly follow the requirements of the operating rules, and shall not conduct illegal operations at non-operating positions. To ensure the reliability of safety devices, safety measures must not be compromised in pursuit of efficiency.
6. When the plastic granulator machine is operated, the material temperature does not reach the set temperature, and when the holding time is not enough, the starting screw is not allowed to run.
7. Operated by an operator who is trained and familiar with the performance and operating procedures of plastic mechanical structures.

Category: News

Make an Enquire

Your email address will not be published. Required fields are marked *